[Knowledge Base] How to use firmware recovery function of Pharos CPE

Purpose of this article:
Firmware upgrade may not be successful sometimes, for instance unpredictable power failure during the process, and thus your Pharos device may fail to reboot. This article will guide you how to re-flash the firmware via TFTP.


Prerequisites:
1. Install the Tftpd32 /Tftpd64 on your computer based on the system type(32-bit/64-bit), here we take Tftpd32 as an example ;
Download link: http://tftpd32.jounin.net/tftpd32_download.html
2. Download the proper firmware of Pharos CPE products, here we take firmware pharos_un-up-ver1-0-0-P25-[20140709-rel51929].bin of CPE510 as an example, then must rename the firmware as recovery.bin;
3. Configure IPv4 address of your computer as 192.168.0.100/255.255.255.0, you can click Here to configure static IP for the computer.
Firmware Recovery ProcedureStep1
Connect your computer to the LAN port of CPE510 with an Ethernet cable and run the Tftpd32.exe, then navigate the Current Directory to the folder where recovery.bin is stored.

Step2
Power Pharos device off first. Press the reset button on CPE510 and then power it on. Hold the reset button for about 6-8 seconds and focus on Tftpd32.exe interface at the same time. When you see the file transfer progress bar appears as below, then you can release the reset button.

Step3
CPE510 will reboot automatically after the file transmission completed, please wait for a while until all the lights on CPE510 are flashing and then perform normally.

Step4
After reboot you may follow this link to login the management page of CPE510 again.

Note:

1. Please only perform firmware recovery through wired connection.
2. Tftpd32 exe/Tftpd64 exe should be compatible with the Operating System, Tftpd32 exe should work with 32-bit System and Tftpd64.exe should work with 64-bit System.

Source: [Knowledge Base] How to use firmware recovery function of Pharos CPE

5 Replies to “[Knowledge Base] How to use firmware recovery function of Pharos CPE”

  1. I install the netsequre on my tplink Pharos CPE 510 but I can’t remove this firmware can any one help please????

    1. Sorry, cant help. But I suggest you to talk to TP Link support. I have talk to them for my vlan problem and they solve it well. But when I talk to support team, I use official firmware. I don’t know if they want to help with your problem if you use other firmware.

Leave a Reply to Bewar Cancel reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.